Check the Engine Ignition and Fuel System: In most cases, the problem with a scooter not starting but with power is caused by an issue with the engine; either a bad spark plug wire, bad plug or a fuel system problem. … This is caused by a problem with the spark plug, spark plug wires, or the ignition coil.
What do you do if your scooter wont start?
If the scooter does turn over but still doesn’t start you have to check for a spark and make sure gas is getting to the engine. To check for a spark, remove the spark plug from the cylinder, hold the tip of the plug against the cylinder head and crank the engine. You should see a spark across the gap.
Can you push start a scooter?
Kickstarting an automatic scooter is the same as kickstarting a bike or any other scooter. You have to turn the ignition key on and push on the kickstart lever swiftly. It may take two or three tries. To push start an automatic scooter, you will need a cable or a rope.
How do you stop a scooter engine?
Insert your finger or any thing that blocks the silencer the engine rpm will lower and stop. open the silencer hole all the smoke will come out. Use choke and accelerate a little engine will stop. When engine is idling suddenly throttle to the fullest chances are there that engine may switch off.
Why does my scooter not accelerate?
Worn Out or Dirty Spark Plugs
When your bike is not accelerating, one of the reasons could be that the spark plugs are worn out. Basically, the plugs have lost their effectiveness in causing a spark. When this happens, they are unable to cause an ignition. If there is no ignition, the bike does not accelerate.
Does Kick Start need battery?
Electric starter and the Kick start. While the electric starter uses the battery for ignition, kick start is a mechanical way of doing it. … Simply put, CDI systems do not require battery to start the engine. As a result, the mechanical kick start is not dependent on your batteries.
What would cause a motorcycle not to start?
Most of the time if your bike will not start it is something as simple as making sure the fuel control valve is not clogged with rust; making sure corrosion has not built up within the valve itself causing dry rot, cracking, or leaking. … If the bike is not already in neutral, go ahead and put it there.
What happens when starter relay goes bad?
If your starter relay has gone bad, the electrical signal will never make it from the battery to the starter motor. As a result, your engine won’t turn over – no matter how many times you turn the key. A faulty relay often produces an audible clicking sound when you turn your car.