You should be able to make the shift to the largest cog easily. You should also see two slight bends at each jockey wheel of the rear derailleur. If the chain is too short, this shift is difficult to make and the derailleur cage is stretched out and almost parallel to the chainstay.
How do I know if my bike chain will fit?
The method of chain sizing depends upon the range of gearing in the system. For bikes with rear sprockets 36 teeth and smaller, the common system is to measure using the largest rear sprocket and largest front ring as a reference. Two rivets are added to this (one-inch) for the place to cut the chain.
How long should a chain be on a bike?
Using a ruler, a new chain should measure exactly 12 inches across 12 links, from middle of pin to middle of pin. The number most commonly agreed on for a worn chain is one percent elongation between links. In reality though, you want to replace the chain before this point.
Is my bike chain tight enough?
Check your chain out. It should be tight enough that it only allows you to move it up and down about one inch. If it is sagging or much looser than that, you need to tighten that chain up. Chains often loosen when a bike does not have a derailleur.
How tight should a road bike chain be?
The chain should be tight enough that it only allows you to move it up and down about half an inch. If there is no slack in the chain then it is too tight. And if there is too much slack then you need to tighten that chain.
What size chain should I get?
After a measurement is obtained, its a good idea to opt for a necklace size that is at least the second size up from your neck size. For example, if you have an 18 inch neck, you should probably choose a chain length of 20 inches or more. An 18 inch chain would feel too tight.
When should I replace my bike chain?
If you are using a chain designed for ten or fewer gears, replace your chain as it nears the 0.75 percent mark. If you are using an eleven or twelve speed chain, replace your chain once it has reached 0.5 percent wear. For two-sprocket or single speed bikes, replace your chain as it reaches the 1 percent wear mark.
A new bicycle chain usually comes with 116 links. This is long enough for the biggest chainrings and for most distances of rear wheel from front chainrings. So for optimal length a new chain is usually shortened from the 116 links that come in the box.
What happens if bike chain is too long?
If the bike chain is too long it will cause problems when changing gears as you shift gears and the derailleur can’t pick up the extra chain length. As a result, the chain may keep slipping off. … Your front and rear derailleur are not properly aligned. The chainring, derailleur, or the chainring are damaged.
How does chain length affect shifting?
A chain that’s too long (loose) may cause dropped chains and/or inconsistent shifting — front and back shifting. A chain that’s too short (tight) can cause even bigger problems.
How do I know if my chain is too loose?
To find out whether your chain is too long take a look at it from the side with your eyes being level with the chain. A loose chain will sag close to or below the chainstays as the chain hangs between the rear cogs and chainring. The chain might skip as you pedal, or even drop off the gears.
Can a bike chain stretch?
Do bicycle chains really stretch? The short answer is no, however they do wear in such a way as to cause their maximum length to increase. Mechanics usually refer to this as chain “stretch.” It is the sign of a worn out chain that should be replaced. Illustration of extreme wear on a chain pin.
How tight should the chain be on a single speed bicycle?
There should be approximately one half inch of movement in the chain up and down at a point half way between the front and rear sprockets. To change the tension loosen one of the axle-nuts and move the wheel forward or backward slightly and snug it up again.