To find out whether your chain is too long take a look at it from the side with your eyes being level with the chain. A loose chain will sag close to or below the chainstays as the chain hangs between the rear cogs and chainring. The chain might skip as you pedal, or even drop off the gears.
How Loose Should a bicycle chain be?
It should be tight enough that it only allows you to move it up and down about one inch. If it is sagging or much looser than that, you need to tighten that chain up. Chains often loosen when a bike does not have a derailleur. … Bikes without a derailleur are single-speed bikes or fixies.
Should my bike chain be loose or tight?
The rule of the thumb says that the exact tightness of a chain will only let you move for about half an inch. Now, if the chain is too loose, then you need to tighten it. If you cannot even move the chain, then it is too tight, and it needs to be loosened.
How much play should a bicycle chain have?
There should be approximately one half inch of movement in the chain up and down at a point half way between the front and rear sprockets. To change the tension loosen one of the axle-nuts and move the wheel forward or backward slightly and snug it up again.
How do you check bike chain tension?
To check the correct chain tension is to see if you are able to move it around half an inch in either direction. If you are happy will how tight the chain is. Then you can tighten the rear axle nuts one by one.
Why is my bike chain slipping?
Most of the time, a skipping chain is caused by cable stretch. In the first half dozen rides on a new bike your shift cables stretch the most. They can also stretch over time as you ride. … Shift down into the smallest ring in the rear cassette again, and press your shifter again to see if the bike shifts properly.
Can a bike chain stretch?
Do bicycle chains really stretch? The short answer is no, however they do wear in such a way as to cause their maximum length to increase. Mechanics usually refer to this as chain “stretch.” It is the sign of a worn out chain that should be replaced. Illustration of extreme wear on a chain pin.
What happens if the chain is too tight?
With a chain being too tight, that causes tightness and stress on the rear suspension. This can be quite uncomfortable for the rider. The chain itself will also become worn out much more quickly. The stress between each link may become too much and, in extreme cases, may break while you’re out for a ride.
How do you tighten a derailleur chain?
Tighten the cable
Select the highest gear (smallest sprocket) on the shifter. Pull the cable as tight as possible at the derailleur and attach it to the body via the cable anchor. Once you’ve done this, select the third gear on the shifter and gently pedal forwards to shift the chain.
Why does my chain keep falling off?
It might be that the chain is worn, has a stiff or bent link, or has become clogged up with dirt. A visual inspection while turning the cranks should reveal if there’s a problem here. The chainring, or a chainring tooth, could be bent.